The standard hammers used in our mills are double end reversible types, which have four wearing edges. When hammers become dull to the point where the machine is not grinding efficiently or when the hammers are well rounded, turn the hammers so a new sharp edge will be in service. One row of hammers should… Read more »
PART ACTION FREQUENCY Bolts Inspect Tighten Daily Guards Inspect Daily Belts Inspect Daily Magnets Inspect Daily Hammers Inspect Weekly Rotate The striking edge is worn. Replace All 4 edges worn. Screen or Inspect Weekly Grate Replace Excessive wear Bearings Inspect Weekly Refill As needed Hammer Rods Inspect Each time you rotate hammers Replace – When… Read more »
Note: Always replace bearings in pairs.
To prepare for replacement, contact us for a set of replacement hammers. Each row of hammers is wired into a specific order and balanced as a set at the factory. You must maintain the order of the hammers and this balance as you make changes. If you do not, the unbalanced hammers can cause excessive… Read more »
Machines that reduce the size of a material also erode the grinding elements. In general, the more abrasive the material you grind, the more quickly the wear parts in the interior will wear. To ensure efficient operation and longevity of your Hammer mill, it’s crucial to regularly inspect and maintain its wear parts. These components… Read more »