工廠磨機 & 轉子重建服務

Restore Performance. Extend Equipment Life.

Give your Schutte Hammermill, CSE Bliss or KannaMill equipment a second life with factory rebuild services tailored to its actual condition. Depending on the equipment and the situation, we can begin with a preliminary review or receive the mill or rotor directly for inspection at our Buffalo factory.

Why Rebuild?

Industrial hammer mills are built to last, but rotors, liners, screens and hammers naturally wear over time. As wear advances, a mill may lose throughput, produce less consistent output, vibrate more or require more frequent maintenance. That does not automatically mean the mill must be replaced.

A factory rebuild allows us to evaluate the equipment, identify worn components and establish a repair scope based on its condition. The objective is to restore reliable operation and extend the useful service life of the equipment.

REQUEST A REBUILD REVIEW

Factory Rebuild Services

Reduced throughput under otherwise similar operating conditions

Less consistent finished particle size

Increased vibration or unusual noise

Visible wear to the rotor, liners, screens or hammers

More frequent maintenance or unplanned downtime

These symptoms can have more than one cause. A preliminary review or factory inspection can help determine whether wear-component replacement, a rotor rebuild or a more complete mill rebuild should be considered.

HOW THE REBUILD PROCESS WORKS

Start with information or direct shipment.
Send the available make, 模型, serial number and photos, and describe what the mill is doing. You can also call us directly. Depending on the situation, we may begin with a preliminary review or arrange for direct shipment.

Factory inspection in Buffalo.
After the mill or rotor arrives, our team inspects the equipment and identifies the work appropriate to its condition.

Confirm the rebuild scope.
The inspection establishes the recommended scope, which may include rotor rebuilding; new liners, screens and hammers; dynamic balancing; and factory testing.

Rebuild, balance and test.
We complete the approved scope and perform the applicable balancing and factory testing before shipment.

To get started, send whatever information you have available: make, 模型, serial number, photos and a description of the symptoms. If direct shipment is the better next step, we can discuss factory inspection at our Buffalo facility.

孟加拉機器品牌家族的成員