任何已移动或旋转部件的机器需要日常的维护，确保其执行在最优容量. 这是特别真实的大小减少设备已磨将随着时间的推移穿的元素. Schutte Hammermill equipment is very ruggedly constructed and with proper routine maintenance will remain in service for many years to come. 要实现这一目标, 我们建议所有的磨损部件的定期检查.
定期检查和更换是必要组件将穿. 为了避免代价高昂的停机, 我们建议，每个以下组件的一套保存在手边.
Inspecting and replacing wear parts:
锤子
Important to Know:
- 取决于应用程序, 锤子将 2 路或 4 路可逆, 该值指示可能更换前旋转的圈数.
- 锤子应该旋转时切削刃是圆润和这台机器不是在最高效率.
- 在工厂平衡集改总是到锤.
何时替换:
- 当两个全切割边缘圆形的取代锤子.
- Replace hammers when there is a noticeable imbalance of hammer edge wear on any (or several) individual rows.
锤杆
Important to Know
- 作为一种最佳做法, 锤杆应检查每次锤是旋转或替换.
何时替换
- 一旦他们成为槽取代锤杆.
- Replace hammer rods if they exhibit any taper wear near end caps, lock nuts or other affixing device.
屏幕 & 酒吧炉排
Important to Know
- 屏幕, 或栏格栅, 是在确定成品的粒度的关键因素.
何时替换
- Replace screens when the perforations become elongated or when there is a hole larger than any two perforations (屏幕)
- 或酒吧边缘变为圆角 (炉排).
耐磨板
Important to Know
- Wear plates are commonly used on equipment processing hard and/or abrasive materials. 这些可更换的组件保护轧机机架, 延长机器使用寿命.
何时替换
- Replace wear plate when they show signs of thinning. Earliest signs of thinning will be seen around the bolt heads. It is critical that the plates be replaced prior to the wear-induced release of any bolts.
轴承
Important to Know
- 轴承承受的荷载，转子和随着时间的推移，可以磨损. 它被建议被替换成对.
何时替换 (or otherwise perform maintenance)
- 更换轴承，如果他们给出过多的热量,
- 外环开始旋转,
- 轴承振动在其屋内的迹象,
- 如果轴承发出不寻常的哀鸣或尖叫