我们工厂使用的标准锤子是双头可翻转型, 它们有四个磨损边缘. 当锤子钝到机器无法高效研磨或锤子边缘已完全磨圆时, 将锤子翻转，使新的锋利边缘投入使用. 每次应只转动一排锤子，以免改变转子平衡. 不要让锤子磨损过度，否则你将失去相对的两个切削刃. 可以通过磨机的检修门更换锤子，锤杆可以从磨机顶部两侧的检修门滑入, 或通过主检修门.
你们的Schutte锤式磨安装的锤子在工厂里已经仔细平衡过. 从我们工厂发送的新套替换锤子也经过仔细平衡，并按排线好. 每次只操作一排锤子，不要将锤子从一排互换到另一排. 不小心操作锤子会导致过度震动.
安装说明: 按钟表平衡法
注意: 到货时, note that each row or stack of hammers are numbered on the top hammer. They are numbered 1-8.
- Start with the row marked “1”. As illustrated in Figure #1, insert one hammer between every other disc. (In some cases, two hammers will be placed between each disc, depending on style of rotor).
- Row 2 will follow with the hammers being staggered between the discs opposite the previous row. (See Figure #2)
- Continue installing the hammers in this manner working around the rotor in numerical order. (See Figure #1)
- Each hammer has four (4) wearing edges. Hammers should be rotated when the grinding edge wears to approximately half way between the hole and the original corner. Do not allow hammers to wear beyond this point or you will lose the ability to utilize all four edges. (See Figure #3)
- 建议在锤杆出现磨损迹象时更换锤杆 (作为一般经验法则, 在使用锤子的四个边角后更换整套锤杆). 在旋转锤子时, 检查锤杆本身是否过早磨损. 锤杆过度出现槽痕时表示需要更换.
- 在旋转或更换锤子后，在每根锤杆的末端安装护圈或开口销.
